EMC B Series

System specifications
59
Specifications
System specifications
Table 12 lists the system specifications for the DS-300B.
Table 12 General Specifications
Specification Description
Autoconfiguring port types F_Port, FL_Port, M_Port, N_Port, and E_Port
System architecture Nonblocking shared-memory switch
System processor IBM PowerPC 440EPx, 667 MHz
SDRAM 512 MB DDR2 SDRAM onboard memory operating at 133 MHz
Compact flash 1 Gigabyte
ANSI Fibre Channel protocol FC-PH (Fibre Channel Physical and Signaling Interface standard)
Modes of operation Fibre Channel Class 2, Class 3, Class F
Fabric initialization Complies with FC-SW-2 6.6
Ethernet port One 10/100BaseT Ethernet port; accessed through RJ45 connector
Terminal port One UART interface for terminal, accessed through RJ-45 connector
ASIC Goldeneye-2 ASIC for Fibre Channel Switching
Port Status LEDs 24 LEDs (green/amber) to indicate status for each port
System Power LED One LED (green) to indicate system power
System Status LED One LED (green/amber) to indicate system status
Ethernet LEDs Two Ethernet LEDs to indicate speed and link status
Power supply One fixed power supply (not a FRU)
Fans Three fixed fans operating at dual speeds (not a FRU).
FC-IP (IP over Fibre Channel) Complies with FC-IP 2.3 of FCA profile
Aggregate switch I/O bandwidth 384 Gbps if all 24 ports running at 8 Gbps, full duplex
Port-to-port latency Less than 700 nanoseconds with no contention (destination port is free)