EMC VNXe3100 - Attach the Bezels

To Next Page

To Previous Page

VNXe3100 Installation Guide

Figure 13 DPE Front LEDs

IMPORTANT

Ensure the power-up is complete and that the system is ready before you continue.

Attach the bezels

1. Locate the bezels for each installed component.

2. Attach the bezel that corresponds to each component as shown in

Figure 14 on page 19. Each

bezel can be locked in place by turning the key one quarter turn clockwise.

Installation

SAS 450 GB 15K RPM

Disk drives

(Blue)

DPE Power On

(Blue)

Other manuals for EMC VNXe3100