EMC VNXe3100 - Replace the memory module

4 VNXe3100 Installation Guide
Unpack your system
This document applies to both single and dual SP configurations. If you have a single SP
configuration, ignore references to SP B.
Unpack the shipping boxes
Verify that you have received all of the system components, including cables, bezels, rails, and
screws (shown below).
Figure 1 Shipping Contents
Disk-array enclosure (Optional)
(DAE)
Disk processor enclosure
(DPE)
SAS (serial attached SCSI) cables
2 per DPE
1 per DPE
Bezel with key
X4
6Gb SAS
1
#
X4
6Gb SAS
X4
6Gb SAS
1
#
X4
6Gb SAS
1
1
G
b
E
01
X4
6Gb SAS
6Gb SAS
23
1
1
G
b
E
01
X4
6Gb SAS
6Gb SAS
23
1
0
1
0
Installation
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
Installation
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
SAS 450 GB 15K RPM
Front
Rear
Adjustable rail kit
Screws
Power cords
2 per DAE
Service cable
2 per DAE
Front
Rear
Adjustable rail kit
Screws
Power cords
Bezel with key
Documentation kit, including Installation
Guide, Quick Start poster, Configuration
Worksheet and sheet of cable labels.