24 EMBROIDERING AND MONOGRAMMING
Be sure to make the following arran-
gements.
A). Release pressure of presser foot.
B). Take off presser foot.
C). Push "DARN" button to drop
fabric feeder.
D). Release the thread tension regulator.
E). Set Buttonhole Dial at "M "
Fig. 44
1. Put material into embroidery hoop, then lower the presser foot, then turn the fly
wheel toward you by hand and raise the lower thread through the material so
that both the upper and lower threads are on top of your material.
2. Sew at medium speed. Move material slowly so that the thread will be close
together as in a satin stitch. With a little practice you will be able to do many
types of designs and gain a great deal of pleasure from your machine.
25. DARNING
Be sure to make the following arran-
gements.
A). Take off presser foot.
B). Push "DARN" button to drop
fabric feeder.
C). Set Buttonhole Dial at "M :
D) . Set zig zag dial at " :"
Fig. 45
1. Place the material under the foot
and lower the presser bar.
NOTE: This enables you to move the material in any direction while the machine
is running.
2. Sew around the areas you desire to darn. Then move the material back and
forth, sewing out beyond the worn or open place in the material. Continue until
the hole is covered, going both sideways and forward and back.
NOTE: While darning, run the machine at medium speed.
22
To Next Page
Loading...