Emec F Series - Priming

26
1. Connectthepumptomainpower.
2. Rotatefrontpanelknobto70%.
3. Turnonthepump.
4. Rotatedischargeknob(openitcompletely).
5. Thechemicalwillbegintoflowintodischargehose.Closethedischargeknob.
6. Proceedtonormaloperatingmode.
9. Priming / Discharging
8.1 Models
FPDR PAUSE WORK
Constant dosage pump with pause and operating phase. The dosage can be adjusted using the PAUSE
knob (0 to 6 minutes) and the OPERATION knob (0 to 10 seconds). Press ON / OFF to switch the pump
on or off. Pulse frequency: fixed, 1 pulse per second (60 pulses per minute).
Note: if pump is switched off, it will re-start in the operating mode when powered again.
FPDR MANUAL-AUTOMATIC
Pump with adjustable dosage based on the pump capacity% (100% = 150 strokes per minute).
Manual mode: constant dosage.