Emec F Series - Electrical Installation

14
7. Electrical installation
AllelectricalconnectionsmustbeperformedbyAUTHORIZEDANDQUALIFIEDpersonnelonly.
Beforetoproceed,please,verifythefollowingsteps:
  -verifythatpump’slabelvaluesarecompatiblewithmainpowersupply.
  -pumpmustbeconnectedtoaplantwithadifferentialswitch(0,03A 
  sensitivity)ifthereisn’tagoodground.
  -toavoiddamagestothepumpdonotinstallitinparallelwithheavy 
  inductanceload(forexample:engines).Arelayswitchmustbeused.See 
  belowpicture.
P - Dosing Pump
R - Relay
I- Switch or safety device
E - Electrovalve or inductance load
A - Main Power
  -Onpump’smotherboardthereisafurtherprotectionagainstovervoltages 
  (275V-150V)anddistributionlinenoises(4KVformax50µsec)asshown: