Emec F Series - Before to Install Warnings

8
4. Before to Install warnings
Pump’sinstallationandoperativityisperformedin4mainsteps:
Pump’s installation
Hydraulic Installation (hoses, level probe, injection valve)
Electrical Installation (main power connection, priming)
Programming the pump.
Beforetostart,pleasereadcarefullythefollowingsafetyinformation.
IProtective clothes
Wear always protective clothes as masks, gloves, safety glasses and
further security devices during ALL installation procedure and while
handling chemicals.
Installation location
Pump must be installed in a safety place and fixed to the table / wall to
avoid vibration problems!
Pump must be installed in a easy accessible place!
Pump must be installed in horizontal position!
Avoid water splashes and direct sun!
Hoses and Valves
Suction and delivery hoses must be installed in vertical position!
All hoses connections must be performed using only hands’ force!
No tongs required!
Deliveryhosemustbefirmlyfixedtoavoidsuddenlymovements 
   thatcoulddamagenearobjects!
Suctionhosemustbeshorteraspossibleandinstalledinvertical 
   positiontoavoidairbubblessuction!
Use only hoses compatibles with product to dose! See chemical
compatibility table. If dosing product is not listed please
consult full Compatibility Table or contact chemical’s manufacturer!