EMC-60 User Guide
- 14 -
5.2.1 Command # 1: PRIMARY PHONE NUMBER:
If digits are stored in the primary phone number register the phone dials this number
when the PHONE button is pressed. If not connected to a live person, this number will
be called 3 times, after which the phone will hang up and the button will have to be
pressed again to resume the cycle. When the phone is connected to a consolidator in
“Lobby Mode”, the primary phone number should be blank.
To enter the primary phone number, touch <1> <ENTER>. The voice prompt “Primary
phone number” will be heard, after which the required phone number can be keyed-in,
then touch <ENTER>
Note: If the EC-Phone is connected to an auto-dialer or to an off-hook service provided
by the telephone company or to a ringdown device (including a Consolidator in Lobby
mode or Rescue Station in Lobby or Split mode) the primary calling number should be
left blank or contain only a pause. However, an off-hook service or a separate auto
dialer is not recommend as it complicates maintenance and troubleshooting and may
prevent emergency personnel calling back to the passenger.
Note: To access an outside line when connected to an analog extension of a PBX
(switchboard) an initial digit (commonly an 8 or a 9) followed by a pause is required
(program an 8# or 9# followed by the telephone number). Each # creates a 2 second
pause and can be entered multiple times to match the delay for an external dial tone.
5.2.2 Command # 2: SECONDARY PHONE NUMBER:
If digits are stored in the secondary phone number register, the phone dials this number
after the primary phone number did not connect to a live person. If not answered, the
primary and secondary numbers will be called sequentially for three cycles. After 3
unsuccessful cycles, the unit will shut off and the button has to be pressed again to
resume the cycle.
Voice Prompt: “Secondary phone number”
5.2.3 Command # 3: THIRD PHONE NUMBER
If digits are stored in the third phone number register, the phone dials this number after
the primary and secondary phone numbers did not connect to a live person. If not
answered, the three numbers will be called sequentially for three cycles. Press the
PHONE button to start the cycle again.
Voice Prompt: “Third phone number”
To Next Page
Loading...
