EMC-60 User Guide
- 17 -
5.2.12 Command # 12: SECONDARY RING TRANSFER COUNT
As for Command #11, this is the number of rings counted after dialing the “Secondary
Phone Number” to determine ‘no answer’, after which the phone hangs up and either
calls the “Third Phone Number” if it has been programmed or calls the “Primary Phone
Number” again until the end of 3 cycles after which it will return to idle mode and the
PHONE button will have to be pressed again to resume the cycle.
Voice Prompt: “Secondary ring transfer count”
5.2.13 Command # 13: THIRD RING TRANSFER COUNT
As for Commands #11 & #12, this is the number of rings counted after dialing the “Third
Phone Number” to determine ‘no answer’, after which the phone hangs-up and calls the
“Primary Phone Number” again until the end of 3 cycles after which it will return to idle
mode and the PHONE button will have to be pressed again to resume the cycle.
Voice Prompt: “Third ring transfer count”
5.2.14 Command # 14: AUTO ANSWER
The auto answer setting determines whether or not the EC-Phone accepts calls, and if
so, whether the phone will ring or remain silent. See Command #5 for more detail.
Voice Prompt: “Auto answer”
5.2.15 Command # 15: TALK TIME
Talk time is the length of time that the EC-Phone will stay on when a call is made,
beginning as soon as 2-way conversation begins. Before the end of the programmed
talk time, a voice prompt will instruct the operator to press <1> to extend the
conversation, otherwise the phone will hang-up after the programmed time.
Note: The operator may press 1 at any time during the conversation to extend the time
then either hang-up or end the conversation by pressing <*><#>.
Voice Prompt: “Talk time”
5.2.16 Command # 16: OPERATOR WAIT TIME
This is the length of time the EC-Phone will wait for acknowledgement after the call is
answered before hanging-up and dialing the next number in the call sequence. The call
has to be acknowledged by the operator by pressing <1> to speak to the caller.
Pressing <2> for the location announcement does not qualify.
Note: This feature is intended to determine that the emergency call has connected to
emergency personnel and not an automated answering device but can be disabled if
“Operator Prompt” (Command # 17) is OFF (see below).
Voice Prompt: “Operator wait time”
To Next Page
Loading...
