EmerCom Technologies EMC-60 - Command # 36: Alert Sounder; Command # 37: PROTECTED WAKE; Command # 40: CONSOLIDATOR COMPATIBILITY; Command # 41: SIMULATE EMERGENCY CALL

EMC-60 User Guide
- 21 -
5.2.29 Command # 36: Alert Sounder
This activates an alert sounder which plays the moment the phone button is pressed to
reduce prank calls (suggest 32=1).
Voice Prompt: “beep”
5.2.30 Command # 37: PROTECTED WAKE
If Protected WAKE is enabled, the keypad requires “Access Code” (Command # 9) to
activate the keypad after touching <WAKE>.
Touch <WAKE>; the LED will flash. Input the “Access Code” (the buttons are silent); the
LED will turn solid and beep.
If “Access Code” is not known, please call EmerCom Support at 1-844-EmerCom
(1-844-363-7266) with the phone number for remote access.
Voice Prompt: “beep”
5.2.31 Command # 40: CONSOLIDATOR COMPATIBILITY
If Consolidator Compatibility is activated, the EC-Phone supports the connection to a
consolidator or rescue station
Sets to 1 or 2 automatically if an EMCS Consolidator calls into the phone (or 3 for an
LS-250 Rescue Station). See programming table.
Voice Prompt: “Consolidator compatibility”
5.2.32 Command # 41: SIMULATE EMERGENCY CALL
This command provides a remote diagnostic tool to replicate a passenger pressing the
“PHONE” button locally. Enter <1> to confirm. The remote call will terminate and the
simulated emergency call will begin.
Voice Prompt: “Simulate emergency call”
5.2.33 Command # 42: SETTINGS RESET
This command sets all the parameters to factory default EXCEPT for the following:
‘Primary Phone Number’
‘Remote Call’
‘Secondary Phone Number’
‘Maintenance Call’
‘Third Phone Number’
‘Serial Number’
‘Location Announcement’
‘Language’
‘SoundNet Code’
Enter <1> to confirm
Voice Prompt: “Settings reset”