EMC-60 User Guide
- 15 -
5.2.4 Command # 4: LOCATION ANNOUNCEMENT
The location announcement is a voice recording of the building location (name &
address), elevator number and that help is required (maximum 20 seconds), which may
be played by the emergency response center operator by selecting <2> when
answering, or at any time during the call.
To record the announcement, touch <4> <ENTER>. The prompt “Location
announcement – wait for beep” and a beep will be heard, after which the announcement
can be recorded for up to 20 seconds (minimum 3 seconds). Touch <ENTER> when
complete. A quiet background is preferred so the message may be recorded remotely
from a quiet location.
Voice Prompt: “Location announcement – wait for beep – beep”
5.2.5 Command # 5: STATION NUMBER
A unique ID number must be assigned to each EC-Phone in a system without a
Consolidator or Rescue Station in order to select the required phone when calling-in
from an off-site location and connect to the unit. The station number is ignored if the
phone is attached to a Consolidator or Rescue Station.
If Auto Answer (Command # 14) is set to “1”, the passenger will see the call progress
LED illuminate on an incoming call. After the caller selects the desired station, two way
communications will be established. The caller will hear the word “Connected”, the call
progress LED will begin flashing and the passenger will hear the phone ring. If Auto
Answer is set to “2”, the LED will not turn on and the passenger will not hear the phone
ring.
Note: for calling into a group of phones connected to a single phone line, one phone
needs to be set to Station #1 for playback of the operator voice prompt.
Voice Prompt: “Station number”
5.2.6 Command # 6: SERIAL NUMBER PLAYBACK
Factory set. Use playback function to report the serial number (as on the sticker
attached to the faceplate).
Voice Prompt: “Serial number”
5.2.7 Command # 7: FIRMWARE VERSION PLAYBACK
Replays the EC-Phone’s major and minor firmware versions.
Voice Prompt: “Firmware version”
To Next Page
Loading...
