The Gateway names will be used in diagnostic messages and host system
integration to help identify each Gateway. It is recommended that these names be
marked on each physical Gateway, in addition to the configuration settings.
Selecting left or right for Gateway A is for visualization purposes only. It has no
effect on performance or functionality.
Figure B-1: System Settings → Gateway → Redundancy
B.3.1 Connect Gateways
After the redundancy system settings have been configured, the two Gateways must be
connected and undergo a pairing process. To pair both Gateways and form a redundant
system:
Procedure
1.
Connect a PC/laptop to the primary Ethernet port on Gateway A.
2. Log in using the admin user account.
3. Navigate to System Settings → Gateway → Redundancy Status.
4. Connect the secondary Ethernet port on Gateway A to the secondary Ethernet port
on Gateway B (see Figure B-2).
5. After a few minutes, a dialog will appear on the page; select Form redundant pair.
6. Wait for the Pairing to redundant peer status to turn green.
Redundant Gateway systems Reference Manual
May 2020 00809-0600-4410
56 Emerson.com
To Next Page
Loading...
