www.fieldcommunicator.com
USER’S MANUAL
February 2009
375 FIELD COMMUNICATOR
SECTION 2LEARNING THE BASICS
OVERVIEW This section provides instructions on basic features and
functions of the 375 Field Communicator. It also provides
information on starting, entering stand-by, shutting down,
configuring, and maintaining the 375 Field
Communicator. The functionality described in this
section is based on system software version 2.5.
SAFETY
MESSAGES
Procedures and instructions in this section may require
special precautions to ensure the safety of the personnel
performing the operation. Information that raises
potential safety issues is indicated by a warning symbol
( ). Refer to the following safety messages before
performing an operation preceded by this symbol. See
the Troubleshooting section for more warning messages.
IMPORTANT NOTICE
Ensure the battery and the 375 Field Communicator are properly aligned during assembly to
prevent damage to the connector pins.
IMPORTANT NOTICE
Do not pull up on the battery because this can damage the connector pins. The System Card
must be inserted or removed by applying gentle pressure in line with the axis of the System Card
and the System Port. Do not pull up or press down on the System Card because this can
damage the card or the communicator and void the warranty.
WARNING
A Re-Flash operation reinstalls the firmware and software from the System Card. This should
only be performed under the direction of Technical Support personnel.
To Next Page
Loading...
