Emerson AMS 2140 - Table of Contents

Copyright
©
2018 by Emerson. All rights reserved.
No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval
system, or translated into any language in any form by any means without the written permission
of Emerson.
Disclaimer
This manual is provided for informational purposes. EMERSON MAKES NO WARRANTY OF ANY
KIND WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Emerson shall
not be liable for errors, omissions, or inconsistencies that may be contained herein or for
incidental or consequential damages in connection with the furnishing, performance, or use of
this material. Information in this document is subject to change without notice and does not
represent a commitment on the part of Emerson. The information in this manual is not all-
inclusive and cannot cover all unique situations.
Patents
The product(s) described in this manual are covered under existing and pending patents.
Contents
Introduction ................................................. 3
Laser and sensor setup
..................................8
Job setup .................................................... 16
Perform horizontal alignment .....................22
Transfer alignment job data and
tolerances ...................................................33
Print alignment summary reports ............... 36
Verify the AMS Machinery Manager
version ........................................................38
sensALIGN approvals .................................. 39
Quick Start Guide December 2018
2 AMS 2140 Advanced Laser Alignment Application