The FTP site name appears in the Connections pane and the site is started.
8.4.1 AMS Machinery Health Monitor firmware update
Emerson Process Management periodically releases updates to firmware. When you
update your AMS Machinery Manager software, it is a good practice to update the
firmware if a new version is available. Refer to the Readme file (Readme.rtf) on the
Software Installation DVD for information about the current firmware version. These
instructions apply to the following AMS Machinery Health Monitor systems:
• AMS 6500 Machinery Health Monitor
• AMS 2600 Machinery Health Expert
• CSI 4500 Machinery Health Monitor
Install the firmware on the FTP server
Prerequisites
You need the AMS Machinery Manager Software Installation DVD.
Procedure
1. Log on to the computer that hosts the FTP Server for your AMS Machinery Health
Monitor.
2. Insert the AMS Machinery Manager Software Installation DVD.
3. Open the DVD in Windows Explorer and browse to Install/Online Firmware.
4. Double-click setup.exe and continue through the installation.
Important
On Windows 7, right click setup.exe and select Run as administrator.
5. Accept the license agreement.
6. Select the type of installation.
• Select Typical to install the firmware and tools.
• Select Custom to choose to install either the firmware or the tools.
7. Follow instructions presented by the installation program.
The online firmware is installed in C:\Inetpub\ftproot\bin\.
Postrequisites
Cycle the power on each AMS Machinery Health Monitor that uses this FTP server.
Reboot the AMS Machinery Health Monitor
Cycle power on the AMS Machinery Health Monitor and verify the system is in good status
after it boots.
Software configuration
MHM-97125-PBF-EN, R0 71
To Next Page
Loading...
