Emerson Branson 2000 Series - Controlling the Front Panel Display

100-214-251 REV. 05 95
6.3 Controlling the Front Panel Display
The welder has three DIP switch settings for controlling the front panel display:
• Weld Scale Multiplier
• Test Scale Multiplier
• Display Lock
The multiplier settings may be used in low power situations. where the load is less than
50%.
Use Display Lock when you do not want operators to change settings. However you can
restore cold start parameter values with this setting. For further information on setting
these DIP switches, refer to Section 4.11.1 Setting DIP Switches.
If these measures do not resolve your problem. contact your local representative or
Branson’s Product Support Department.
100-214-251 IWoper.book Page 95 Friday, June 16, 2017 4:12 PM