Emerson Branson 2000 Series - Figure 4.24 DIP Switch Location

100-214-251 REV. 05 69
4.11.1 Setting DIP Switches
• Open the left side cover to access the DIP switches which are located on the circuit board located
on the lower right corner immediately behind the front panel.
• Use an insulated probe to alter DIP switch settings.
• After altering a DIP switch, close and secure the left side cover and plug in the power cord.
Figure 4.24DIP Switch Location
WARNING General Warning
Be sure the welder is electrically disconnected before opening the
cover.
NOTICE
These settings are different for the IW and the IW+, and read only at power-up.
100-214-251 IWoper.book Page 69 Friday, June 16, 2017 4:12 PM