28 100-214-251 REV. 05
2
Ground Detect, 15
pin female connector
An optional 2000IW only feature, allows ultrasonic
energy to be turned off when the horn comes in
contact with your electrically isolated fixture or anvil.
Requires Ground Detect Kit, 1010-063-343.
3
Ground Detect, 3 pin
connector
4
User I/O, Alarm
Connector
25 pin D-shell connector provides a +24V DC interface
for external controls and devices. ALARMS, WELD ON
and EXTERNAL RESET signals are available. In
addition, a READY signal is available as both +24V DC
and isolated contact closure. Using this connector,
selected faults or weld errors sensed by the welder can
be communicated outside the welder for monitoring
cycles and sorting suspect workpieces. Connector 4 is a
25 pin female.
5 Start Connector
Connects the welder to its base or to customer
supplied start signals. Connector 5 is a 9 pin male.
6 Air Filter Filters contaminated from the air entering the welder.
7 Line Cord Connects the welder to your power source.
Table 2.4 Rear Panel
Item Name Function
100-214-251 IWoper.book Page 28 Friday, June 16, 2017 4:12 PM
To Next Page
Loading...