Base Enclosure security sealsFigure 3-14:
A. Transmitter Electronics Enclosure
B. Security wire seals
C. Transmitter Electronics endcap security latch
D. Base Enclosure
23. If required, install a security seal wire (maximum wire diameter 0.09 inch; 2.3mm)
on the Transducer Cable Connector to the Transducer Cable Nut by rotating the
Transducer Cable Nut clockwise; compressing the seal on the Transducer Cable
Connector (see Figure 3-15).
Meter repairs
Maintenance and Troubleshooting manual 67
To Next Page
Loading...
