Incorrect sling attachmentFigure 2-14:
10. NEVER apply shock loads to the meter. Always lift the meter gradually. If shock
loading ever occurs, the hoist ring must be inspected per manufacturer's
recommendations prior to any further service. If a proper inspection cannot be
performed, discard the hoist ring.
11. NEVER lift with any device, such as hooks, chains, or cables that could create side
pulls that could damage the ring of the hoist ring.
12. NEVER lift more than the ultrasonic meter assembly including electronics and
transducers with the hoist rings. The only exception that safe is to lift the meter with
one ASME B16.5 or ASME B16.47 blind flange bolted to each end flange of the
Mechanical installation
Installation manual 39
To Next Page
Loading...
