1592026260 IEV22-24D GB r.1.0 21.02.2019 IEV 12/60
3.5 Viewing active alarms, alarm log and the upload function
The following can be viewed by pressing the “menu” key:
• ALrM: active alarms (if present); press to view all the other alarms
• ALoG: alarm log (last 50 alarms with fifo logic)
• UPL: menu to upload the map of parameters (copy the map from HotKey 4K to IEV)
After viewing the last alarm in the AloG menu, ArSt appears on the lower display and PAS on the upper
display. The Alarm log is reset by logging in via the password (default value = 4).
3.6 Viewing the superheating set point
Pushing SET key it will be visualized superheating cooling set point (SHC) or heating set point
(SHH), depending on operation mode at the time.
If the device is configured for both operation mode, in STD-BY the display shows both set point.
To Next Page
Loading...
Need help?
General
