1592026260 IEV22-24D GB r.1.0 21.02.2019 IEV 5/60
1. GENERAL WARNING
1.1 Please read before using this manual
• This manual is part of the product and should be kept near the instrument for easy and quick
reference.
• The instrument shall not be used for purposes different from those described hereunder. It cannot
be used as a safety device.
• Check the application limits before proceeding.
• Dixell Srl reserves the right to change the composition of its products, even without notice, ensuring
the same and unchanged functionality.
1.2
Safety Precautions
• Do not expose the device to water or moisture: use the controller only within the operating limits
avoiding sudden temperature changes with high atmospheric humidity (to prevent formation of
condenses).
• Use the controller only within the operating limits (temperature, humidity, supply power,
characteristics of the connected loads, etc..).
• Caution: Before beginning any maintenance operation, disconnect all electrical connections of
the instrument
• The instrument must not be opened.
• In case of failure or faulty operation send the instrument back to the distributor or to "Dixell srl"
(see address at the end of this document) with a detailed description of the fault.
• Pay attention to the maximum current applied to each relay (see section "Technical Data").
• Ensure that the wires of probes, power supply and power loads are separated and far enough
from each other, without crossing or intertwining.
• symbol is intended to alert the user to the presence of uninsulated "dangerous voltage"
within the product area of sufficient magnitude to constitute a risk of electric shock to persons.
• symbol is intended to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature accompanying the device
• Dixell Srl reserves the right to modify this manual without notice.
• This manual is part of the product and should be kept near the equipment for its consultation.
• The device cannot be used as a safety device.
• The product should not be used in a different way as shown in the documentation.
• The device must always be placed inside a cabinet, accessible only by authorized personnel.
Separate the power supply of the device from power supply of other electrical devices
connected in the electrical panel (use separated transformer). The secondary of the transformer
must not be connected to earth.
To Next Page
Loading...
Need help?
General
