11
August 2017
Installation and Maintenance Manual
E2K-402-0817 Rev. 2
Limit Switch Setting Instructions
2. Disengage spring loaded gear: Push Disengage Shaft in (Fig. 7a) down, then rotate
90° so shaft is captured down. This will disengage limit switch gears from spring
loaded drive gear.
Figure 7
Fig. 7a
Push
Down
Rotate 90°
NOTE:
Many turns may be required to set limit switches; it may be convenient to use a reversible
variable speed drill to rotate the adjusting shafts instead of a screwdriver.
Section 4: Limit Switch Setting Instructions
To Next Page
Loading...
