Emerson ELQ 100 - Connecting the Power Supply

TM
14
Installation Operation & Maintenance manual ELQ
DOC.55.EDN Rev: E
October 2012
6.2 Connecting the power supply.
• Removethefrontcover.
• Mountcableglandinthefrontcover.
• Insertpowercablethroughcableglandandfront
cover.
• Connectpowercabletopowerboard(seeg.
6.1.1/6.2.1).
• Mountfrontcoverindesiredposition(seeg.
6.2.1).
• Installcableglandandmountthecover
6.3 Main fuse replacement
Table 6.2 Internal main fuse ELQ-actuators
Actuator Fuse type Dim.
ELQ100/200/300/500/800 T10A ø 5 x 20 mm
6.2.1 Connect power cable to power board
Forpipeconnectionseeg.6.2.2.
6.2.2 Pipe connection
6.3.1 Main fuse
Important
• Afteradjustmentsalwaysmountthecoverto
thehousing.
• Takecarethatthecoversealisinplaceto
complytodustandwatertightnessaccording
toIP65,IP67orNEMA4.