Emerson IC695PNS001-BHBF1 2 - Page 10

GFK-2738AE Jan 2024
7
Front Panel LNK LED
The Front Panel LNK LED indicates the link established on the front Ethernet port.
LED
Color
Description
Green, on
Ethernet link established.
Off
No Ethernet link
Front Panel ACT LED
The front panel ACT LED indicates activity on the front Ethernet port when blinking.
LED
Color
Description
Amber, blinking
Activity on front panel Ethernet port.
Amber, On
No activity on the front Ethernet port, but the link is connected
Off
No link is connected.
Quick Start Guide
Installation and initial startup procedures for the PNS include the following steps. Before installing and operating
the PNS, refer to PACSystems RX3i PROFINET Scanner Manual, GFK-2737, for detailed information.
Pre-Installation Check
Upon receiving your RX3i equipment, carefully inspect all shipping containers for damage. If any part of the
system is damaged, notify the carrier immediately. The damaged shipping container should be saved as evidence
for inspection by the carrier.
As the consignee, it is your responsibility to register a claim with the carrier for damage incurred during shipment.
However, Emerson will fully cooperate with you, should such action be necessary.
After unpacking the RX3i equipment, record all serial numbers. Serial numbers are required if you should need to
contact Customer Care during the warranty period. All shipping containers and all packing material should be
saved should it be necessary to transport or ship any part of the system.