Minimum PNS
Version Required
The following
minimum
backplane hardware revision
must
be used:
IC695CHS012-BAMP IC695CHS016-BAMP
IC695CHS012CA-BAMP IC695CHS016CA-BAMP
or
IC695CHS012-CA (or later) IC695CHS016-CA (or later)
IC695CHS012CA-CA (or later) IC695CHS016CA-CA (or later)
or
IC695CHS007-AA (or later)
When installing, operating, or maintaining the PNS, personnel must ensure any electrostatic charge is
discharged through the use of a grounded ESD strap or other means.
-JC or later backplanes require R3.40 firmware or later.
Rx3i AC
Power Supply
Compatibility
For new installations using AC power supplies, the PNS requires an IC695PSA040H or IC695PSA140D (or
higher) revision power supply to ensure compatibility.
For retrofit installations using AC power supplies, the PNS may require an IC695PSA040H or
IC695PSA140D (or higher) revision power supply depending on the total current load in the backplane. If the
total current load exceeds the existing power supply's minimum current threshold, no power supply change is
required.
Small form-
factor
pluggable
modules
IC695SPC100A or later
IC695SPF002A or later
IC695SPF550A or later
IC695SPF010A or later
For a complete list, refer to
Supported Modules, Power Supplies, and Backplanes
.
Restrictions and Open Issues
Invalid Module Configurations
will cause the respective RX3i
I/O module to fail configuration
When the PNS rejects the configuration of an individual I/O module, that
configuration is not delivered to the I/O module, leaving the module in an
unconfigured state. In many modules, this is indicated by the OK Led on the I/O
Module blinking. In addition, I/O point faults will be asserted for that module’s I/O.
Correct the configuration of the I/O module and store HWC again.
Refer to the section entitled RX3i PROFINET Scanner Configuration Validation in
PACSystems RX3i PROFINET Scanner Manual, GFK-2737.
To Next Page
Loading...
