Emerson IC695PNS001-BHBF1 2 - PROFINET Scanner Status and Control Data

GFK-2738AE Jan 2024
3
PROFINET Scanner Status and Control Data
The RX3i PROFINET Scanner provides 32 bits of input status data and receives 32 bits of output control data.
The application program in the I/O Controller system can monitor the input status bits for the PNS module. The
output control bits are reserved for future use and have no function at this time.
Output Control Bits
PNS001-Axxx hardware: The 32 bits of control output assigned to the PNS module are reserved for future use.
PNS001-Bxxx or later and PNS101-Axxx hardware: The 32-bits of control output assigned to the PNS module
allows the IO Controller to dynamically control aspects of the scanner’s operation. All control bits are active high.
Bit 1 is the least significant.
Bit #
Name
Description
1
FW Update in
Run
A value of 1 allows the webpage firmware update to continue (and restart the PNS disrupting IO)
while the PNS IO is actively controlled.
2–32
Reserved
Set to 0
Input Status Bits
The PROFINET Scanner’s 32 bits of input status provide information about the scanner. All status bits are active
high. Bit 1 is the least significant.
Status
Bits
Name
Description
1
Module OK
Indicates the health of the module. A value of 0 indicates the module is powering up or has
failed. A value of 1 indicates the module is functioning properly
2
Reserved
Set to 0
3
Port1 Link Up
1 = port is connected to another device and is communicating
0 = port is not connected to another device, or the port has some sort of error preventing
communications
4
Port2 Link Up
5
Port3 Link Up
6
Port4 Link Up
7-10
Reserved
Set to 0
11
MRP Enabled
Indicates whether MRP has been enabled or not. A value of 0 indicates that MRP is not
enabled. A value of 1 indicates that MRP is enabled
12
MRP Role
Indicates the MRP role the PNS is operating as when MRP is enabled. A value of 0 indicates
that the PNS is currently an MRP Client. A value of 1 indicates that the PNS is currently an
MRP Manager, however, the PNS does not currently support MRP Manager configuration. If
MRP is not enabled, then this bit will be set to zero.
13
Clock Sync’d
PNS101: The internal clock has been synced to the IRIG-B clock source. This bit may take up
to 90 seconds to turn on after the IRIG-B clock is available.
PNS001: Set to 0
14
SoEs Avail
PNS101: SoE Records are available for upload.
PNS001: Set to 0
15-32
Reserved
Set to 0