Emerson IC695PNS001-BHBF1 2 - Page 19

GFK-2738AE Jan 2024
7
Problems Resolved by this Revision
Subject
Defect
Description
IC695PNSx01
Overtemperature resets
DE10626
The IC695PNS001-Bxxx or IC695PNS101 could incorrectly indicate an
overtemperature condition and reset even when the operating
temperature is within normal ranges.
Functional Compatibility
The following CPU firmware, programming software, and backplane hardware versions are required to use the
features introduced in the most recent PNS release:
Subject
Description
Feature
Minimum PNS
Version Required
Minimum Version Required
Firmware
Version
Single fiber break
detection
PNS001-Bxxx/PNS101
Release 3.40
CPE330 Release 10.30
CPE400/CPL410 Release 10.30
CPE302/305/310 Release 10.30
IC695CMM002/004,
IC695PSD180 support
PNSx01-Bxxx/PNS101
Release 3.35
CPE330 Release 10.30
CPE400/CPL410 Release 10.30
CPE302/305/310 Release 10.30
Sequence of Events
with Five PNS101s
PNS101 Release 3.30
CPE330 Release 10.15
CPE400/CPL410 Release 10.15
PNS101 &
CPE400/CPL410
Sequence of Events
with MDL655/MDL660
PNS101 Release 3.26
CPE400/CPL410 Release 10.10
PNS101 & CPE330
Sequence of Events
with MDL655
PNS101 Release 3.25
CPE330 Release 9.60
PNS101 & CPE330
Sequence of Events
with MDL660
PNS101 Release 3.10
CPE330 Release 9.60
PNS001-Bxxx
PNS001-Bxxx Release
3.00
CPU320/CPU315 Release 8.95
CPE310/CPE305 Release 8.95
CRU320 Release 8.95
CPE330 Release 8.95
CPE400 Release 9.00
CPL410 Release 9.55
CPE100 Release 9.15
CPE115 Release 9.45
RXi Controller Release 7.80
9
PNS001-Axxx
(Most Recent Release)
PNS001-Axxx Release
2.41
CPU320/CPU315 Release 8.95
CPE310/CPE305 Release 8.95
9
HART Pass Through COMMREQ feature not supported on RXi Controller. Refer to future RXi Controller IPI for updates.