Emerson iPro.Genius - 9 Connections; The Dac Connector Descriptions

32 • The DAC Connector Descriptions 026-1727 Rev 3
9 Connections
9.1. The DAC Connector
Descriptions
Connector Function
Connector for 24VAC/DC power
supply analog inputs 
(Pb1 - Pb10, PbC)
Additional power (+5VDC,
+12VDC, GND)
Opto-insulated analog outputs
(O
ut1 - Out6, GND)
24VAC/DC power supply for the
opto-insulated analog output
Volt-free opto-insulated digital
inputs (DI1 - DI20, IDC)
USB port for downloads (BIOS,
ISa
GRAF® application, maps of
parameters, remote display
applications, network
configuration, website) and
uploads (log files)
TCP/IP Ethernet port
Connector for remote terminal
(VISOGRAPH), maximum 2
terminals per DAC.
CANBUS connector for
ex
pansions (IPEXx0D) and
drivers for electronic valves
(XEVx0D) Rx and Tx LED to
indicate that communication is
active Closed circuit terminal
(Term)
RS485 Slave connector
Rx and Tx
LED to indicate that
communication is active
Closed circuit terminal (Term)
Table 9-1 - Descriptions of the Connections
RS485 Master connector
Rx and Tx LED to indicate that
communication is active
Closed circuit terminal (Term)
Digital relay outputs (for digital
outputs with volt-free contacts)
3 NO relays, 1 common
Digital relay outputs (for digital
outputs with live contacts)
3 NO rela
ys, 1 common and 2
volt-free (Neutral)
Digital relay outputs (for digital
outputs with volt-free c
ontacts)
5 NO relays, 1 common
Digital relay outputs (for digital
outputs with live contacts)
5 NO rela
ys, 1 common and 2
volt-free (Neutral)
Digital relay outputs
2 NO rela
ys, 1 common
Digital relay outputs (only for
21
5D versions)
5 NO relays, 1 common and 1
volt-free (Neutral)
Connector Function
Table 9-1 - Descriptions of the Connections