40 • Relay Output Overrides with Visograph 026-1727 Rev 3
10.2.2.Relay Outputs
1. Press the RIGHT arrow to navigate to the
relay outputs configuration screen.
The current configuration of local relay outputs
1-10 are shown on this screen.
2. Press the RIGHT arrow to navigate to the
next screen showing outputs 11-15.
10.2.3.Analog Outputs
Press the RIGHT arrow to navigate to the analog
outputs configuration screen. The current
configuration of all local analog outputs are shown on
this screen:
10.2.4.Digital Inputs
Press the RIGHT arrow to navigate to the digital
inputs configuration screen. The configuration of all
supported digital inputs are shown on this screen.
All digital inputs are fixed in position and cannot
be edited.
10.3. Relay Output Overrides
with Visograph
1. Press 6 on the main menu to navigate to the
output override screens
The first override page shows all of the relay
outputs. To override a relay:
2. Use the UP and DOWN arrows to navigate to
the desired relay output.
3. Press the ENTER key. The field will start
blinking.
Figure 10-4 - I/O Config - Analog Inputs
Figure 10-5 - I/O Config - Relay Outputs 1-10 and 11-15
Figure 10-6 - I/O Config - Analog Outputs
Figure 10-7 - I/O Config - Digital Inputs
To Next Page
Loading...
