EasyManua.ls Logo

Emerson Liebert Prop Fan Condensing Unit - Figure 8 Electrical Field Connections, 8-Ton Units

Emerson Liebert Prop Fan Condensing Unit
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation
10
Figure 8 Electrical field connections, 8-ton units
Factory-wired
to components on
electric panel
DPN000135
Rev. 1
Electric service
connection to contactor
or terminal block
Single- or three-phase electric
service not provided by Liebert
High-voltage
electric power
supply entrance
Low-voltage electric
power supply
entrance
Earth ground connection
terminal for field wiring
Field-supplied unit
disconnect switch
Single- or three-phase
electric service not provided
by Liebert
Field-supplied 24V
NEC Class 2 wiring
to evaporator module
Heat rejection connection.
Field-supplied 24V NEC
Class 2 wiring.
Wire connections from evaporator module:
1. 24V GND System 1
2. 24V Supply System 1
3. High Pressure Alarm System 1
4. Hot Gas Bypass Connection System 1
5. 24V GND System 2
6. 24V Supply System 2
7. High Pressure Alarm System 2
8. Hot Gas Bypass Connection System 2
9. 24V GND Condenser Fan
10. 24V SUPPLY Condenser Fan
Refer to tables or unit serial label
for FLA, WSA and OPD values.

Table of Contents

Related product manuals