36
Resetting The System Computer
This system is equipped with a special circuit designed to protect the internal
computer from permanent damage due to unexpected power surges.
If you find that the system does not respond to any commands from the front panel
controls or the remote handset, the system probably experienced a sudden power
surge that activated the protection circuit.
To reset the system after a power surge use the point of a pencil, a toothpick, a
straightened paper-clip or similar object to press the RESET button which is located
in a small opening on the top panel.
The system will return to the Standby (power ‘Off’) mode.
NOTE: Resetting the system computer also clears all of the system memory
and returns the system to its original factory default settings. All of the preset
tuner memories, the clock and the timer settings will be erased after you press
the RESET button. It will be necessary to re-enter the stations in the tuner
preset memories, reset the clock and the timer settings.
MS3108_062806.p65 28/6/2006, 16:5436
To Next Page
Loading...
Need help?
General
