Emerson Powerdrive F300 - Page 17

Powerdrive F300 Getting Started Guide 17
Issue Number: 5
Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting started
Basic parameters
(Menu 0)
Running the
motor
Optimization
NV Media Card
Operation
Further
information
UL listing
information
Table 2-9 Option modules, Keypad and additional options available
For more information refer to the Drive User Guide and the relevant option module user guide.
2.5.1 Parts supplied with the drive
Items such as control terminals, relay connector, 24 V power supply connector, grounding bracket,
surface mount brackets, grounding clamp, DC terminal cover grommets, terminal nuts, supply and
motor connector and finger guard grommets are provided with the drive. For more information refer
to the label on the accessory kit box supplied with the drive.
Type Name Further details
Fieldbus
KI-485 Adaptor
485 Comms Adaptor
485 Comms adaptor provides 485 communication interface.
This adaptor supports 115 k Baud, node addresses between 1
to 16 and 8 1 NP M serial mode.
SI-PROFIBUS
Profibus option
PROFIBUS adapter for communications with the drive.
SI-DeviceNet
DeviceNet option
DeviceNet adapter for communications with the drive.
SI-CANopen
CANopen option
CANopen adapter for communications with the drive.
SI-Ethernet
Ethernet option
External Ethernet module that supports EtherNet/IP and
Modbus TCP/IP
SI-PROFINET
SI-PROFINET V2
PROFINET option
PROFINET adapter for communications with the drive.
Automation
(I/O
expansion)
SI-I/O
Extended I/O
Increases the I/O capability by adding the following
combinations: Digital I/O, Digital Inputs, Analog Inputs
(differential or single ended), Analog Output, Relays.
Keypad KI-HOA RTC Keypad
LCD keypad option
Keypad with a LCD display and real time clock.
Back-up
SD Card Adaptor
SD Card Adaptor
Allows the drive to use an SD card for drive back-up.
SMARTCARD
SMARTCARD
Used for parameter back-up with the drive.
Powerdrive F300 Getting Started Guide English Iss2.book Page 17 Tuesday, July 28, 2015 3:23 PM