Powerdrive F300 Getting Started Guide 47
Issue Number: 5
Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting started
Basic parameters
(Menu 0)
Running the
motor
Optimization
NV Media Card
Operation
Further
information
UL listing
information
Table 5-1 Active action icon
5.2 Keypad operation
5.2.1 Control buttons
The keypad consists of:
• Navigation Keys - Used to navigate the parameter structure and change parameter values.
• Enter / Mode button - Used to toggle between parameter edit and view mode.
• Escape / Exit button - Used to exit from parameter edit or view mode. In parameter edit mode, if
parameter values are edited and the exit button pressed the parameter value will be restored to
the value it had on entry to edit mode.
• Three control buttons - used to select Hand / Off / Auto modes (see section 5.2.2 below).
5.2.2 Hand / Off / Auto
Hand / Off / Auto functions are enabled if Pr 01.052 is set to a non-zero value, otherwise the keypad
buttons are allocated as follows:
• Blue - Forward/Reverse
• Green - Run
• Red - Reset
When Hand / Off / Auto functions are enabled (Pr 01.052 set to either 1, 2 or 3), then the keypad
buttons will be allocated as follows:
• Blue - Auto
• Green - Hand
• Red - Off/Reset
The value in Pr 01.052 selects Hand/Off/Auto mode on power-up as shown in Table 5-2.
Active action icon Description
Row
(1=top)
Priority
in row
Accessing non-volatile media card 1 1
Alarm active 1 2
Keypad real-time clock battery low 1 3
Drive security active and locked or
unlocked
14
User program running 3 1
Keypad reference active 4 1
Powerdrive F300 Getting Started Guide English Iss2.book Page 47 Tuesday, July 28, 2015 3:23 PM
To Next Page
Loading...
