Powerdrive F300 Getting Started Guide 45
Issue Number: 5
Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting started
Basic parameters
(Menu 0)
Running the
motor
Optimization
NV Media Card
Operation
Further
information
UL listing
information
4.6 Communications connections
The drive offers a 2 wire 485 serial interface. This enables the drive set-up, operation and monitoring
to be carried out with a PC or controller if required. The drive provides two parallel RJ45 connectors
allowing easy daisy chaining. The drive supports the Modbus RTU protocol. See Table 4-1 for the
connection details.
Table 4-1 Serial communication port pin-outs
4.7 Control connections
For information on control connections, refer to the back cover of this guide.
Pin Function
1 120 Ω Termination resistor
2RX TX
3 Isolated 0 V
4 +24 V (100 mA)
5 Isolated 0 V
6 TX enable
7RX\ TX\
8
RX\ TX\ (if termination resistors are required, link to pin 1)
Shell Isolated 0 V
Powerdrive F300 Getting Started Guide English Iss2.book Page 45 Tuesday, July 28, 2015 3:23 PM
To Next Page
Loading...
