Emerson Powerdrive F300 - Page 69

Powerdrive F300 Getting Started Guide 69
Issue Number: 5
Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting started
Basic parameters
(Menu 0)
Running the
motor
Optimization
NV Media Card
Operation
Further
information
UL listing
information
7.2.2 RFC-A mode (Sensorless)
Induction motor with sensorless control
Action Detail
Before power-up
Ensure:
• The drive enable signal is not given (terminal 29)
• Run signal is not given
• Motor is connected
Power-up the
drive
Verify that RFC-A mode is displayed as the drive powers
up. If the mode is incorrect see section 5.6
Changing the
operating mode
on page 52, otherwise restore parameter
defaults (see section 5.8
Restoring parameter
defaults
on page 53.
Ensure that the drive displays ‘Inhibit’
Enter motor
nameplate details
Enter:
• Motor rated frequency in Pr 00.047 (Hz)
• Motor rated current in Pr 00.046 (A)
• Motor rated speed in Pr 00.045 (rpm)
• Motor rated voltage in Pr 00.044 (V) - check if or
connection
Set maximum
speed
Enter:
• Maximum speed in Pr 00.002 (rpm)
Set acceleration /
deceleration
rates
Enter:
• Acceleration rate in Pr 00.003 (s to Pr 01.006)
• Deceleration rate in Pr 00.004 (s to Pr 01.006)
Mot X XXXXXXXXX
No XXXXXXXXXX kg
IP55 I.cl F C 40 s S1 °
VHzmin
-1
kW cos φ A
230
400
50 1445 2.20 0.80 8.50
4.90
CN = 14.5Nm
240
415
50 1445 2.20 0.76 8.50
4.90
CN = 14.4Nm
CTP- VEN 1PHASE 1=0,46A P=110W R.F 32MN
I.E.C 34 1(87)
0.02
t
1000rpm
0.03
t
0.04
Powerdrive F300 Getting Started Guide English Iss2.book Page 69 Tuesday, July 28, 2015 3:23 PM