Quick Start Guide
7
March 2018
1.6 In-line gage transmitter orientation
The low side pressure port (atmospheric reference) on the in-line gage
transmitter is located under the sensor module neck label. (See Figure 3.)
Keep the vent path free of any obstruction, including but not limited to paint,
dust, and lubrication by mounting the transmitter so that any contaminants
can drain away.
Figure 3. In-line Gage Transmitter
A. Low side pressure port (under neck label)
2.0 Tagging
2.1 Commissioning (paper) tag
To identify which device is at a particular location, use the removable tag
provided with the transmitter. Ensure the physical device tag (PD Tag field) is
properly entered in both places on the commissioning tag. Tear off the
bottom portion of the tag and write “physical tag” on this portion. This can
now be given to the person who can associate the device ID to the desired
tag.
Figure 4. Commissioning Tag
Foundation Fieldbus revision ITK5
(default option)
Foundation Fieldbus revision ITK6
(option code IT6)
A
Revision: 23
Device Serial Number:
XXXXXXXXXX
Device ID:
0011513051010001440-121698091725
PD Tag:
Tear Here
COMMISSIONING TAG
Device ID:
0011513051010001440-121698091725
PD Tag:
PT- 101
Revision: 23
Support files available at
Emerson.com/Rosemount
PT-101
Support files available at
Emerson.com/Rosemount
Revision: 24
Device Serial Number:
XXXXXXXXXX
Device ID:
001151AA00010001440-121698091725
PD Tag:
Tear Here
COMMISSIONING TAG
Device ID:
001151AA00010001440-121698091725
PD Tag:
PT- 101
Revision: 24
Support files available at
Emerson.com/Rosemount
PT-101
Support files available at
Emerson.com/Rosemount
To Next Page
Loading...
