20
Reference Manual
00809-0200-4702, Rev CA
Section 3: Mounting, Wiring Switches, and Sensors:
Models 702DX22 and 702DX61
February 2013
Mounting, Wiring Switches, and Sensors:
Models 702DX22 and 702DX61
Note
Use caution when handling the power module, it may be damaged if dropped from heights in
excess of 20 feet.
Note
Wireless devices should only be powered up after the Smart Wireless Gateway, in order of
proximity from the Smart Wireless Gateway beginning with the closest device. This results in a
simpler and faster network installation.
Figure 3-2. Power Module Installation
5. Close the housing cover and tighten to safety specifications. Always ensure a proper
seal by installing the electronic housing covers so that metal touches metal, but do not
over tighten.
6. Position the antenna such that it is vertical, either straight up or straight down, as
shown in Figure 3-3. The antenna should be approximately 3-ft. (1 m) from any large
structures or buildings, to allow clear communication to other devices.
Figure 3-3. Antenna Positioning
Possible antenna rotation shown.
Antenna rotation allows for best
installation practices in any
configuration.
To Next Page
Loading...
