75
Reference Manual
00809-0200-4702, Rev CA
Section 7: Mounting, Wiring Switches and Out-
put Circuits, Models 702DX32 and 702DX42
February 2013
Mounting, Wiring Switches, and Output Circuits:
Models 702DX32 and 702DX42
7.4 LCD Display
If an LCD display is ordered, it will be shipped attached to the transmitter.
The optional LCD display can be rotated in 90-degree increments by squeezing the two tabs,
pulling out, rotating and snapping back into place.
If the LCD pins are inadvertently removed from the interface board, carefully re-insert the pins
before snapping the LCD display back into place.
Installing the Optional LCD Display
To install the LCD display, use Figure 7-19 on page 75 and the following instructions:
1. Remove the LCD cover. Do not remove the instrument cover in explosive environments
when the circuit is live.
2. Put the four-pin connector into the LCD display, rotate to the desired position and snap
into place.
Note the following LCD temperature limits:
Operating:-4 to 175 °F (-20 to 80 °C)
Storage:-40 to 185 °F (-40 to 85 °C)
3. Replace the transmitter cover.
Note
Only use Rosemount Wireless LCD Part Number: 00753-9004-0002.
Figure 7-19. Optional LCD Display
LCD Display
LCD Cover
LCD
Pins
To Next Page
Loading...
