Emerson Rosemount 702 - Verifying Operation

79
Reference Manual
00809-0200-4702, Rev CA
Section 8: Commissioning: Models 702DX32 and 702DX42
February 2013
Commissioning: Models 702DX32 and 702DX42
8.4 Verifying operation
There are four ways to verify operation: using the optional local display (LCD), using the Field
Communicator, using the Smart Wireless Gateway's integrated web interface, or by using AMS
Suite Wireless Configurator. If the Rosemount 702 transmitter was configured with the Network
ID and Join Key, and sufficient time has passed, the transmitter will be connected to the
network.
Troubleshooting
If the device is not joined to the network after power up, verify the correct configuration of the
Network ID and Join Key, and verify that Active Advertising has been enabled on the Gateway.
The Network ID and Join Key in the device must match the Network ID and Join Key of the
Gateway.
Operating the local LCD display
During steady state operation, the LCD gives a periodic display of user-chosen variables at the
configured wireless update rate. These variables can be chosen from a list of six: Channel 1 State,
Channel 1 Count, Channel 2 State, Channel 2 Count, Electronics Temperature, and Supply
Voltage. The chevron-shaped status bar at the top of the screen indicates the progress of the
network join process. When the status bar is filled, the device is successfully connected to the
wireless network.
Start-up Display Sequence: When the Rosemount 702 transmitter is first powered up, the LCD
will display a sequence of screens: All Segments On, Device Identification, Device Tag, and then
the user-chosen variables of the Periodic Display.
Diagnostic button display sequence
More detailed diagnostic information can be obtained by removing the display cover of the 702
transmitter, and momentarily depressing the "DIAG" button. The LCD will display the diagnostic
screens as shown below. Press the Diagnostic button to display the TAG, Device ID, Network ID,
Network Join Status and Device Status screens.
Figure 8-2. Start-up Screen Sequence
All Segments Device ID Device Tag
User Chosen
Variables …
X X X X X
X X X X x x x
x x x x x x
702
W I r e l s
A b c d e
f g h
CH1
True