30
Reference Manual
00809-0200-4702, Rev CA
Section 4: Commissioning: Models 702DX22 and 702DX61
February 2013
Commissioning: Models 702DX22 and 702DX61
4.2 Configuring the transmitter to communicate with
the wireless network
In order to communicate with the Smart Wireless Gateway, and ultimately the Information
System, the transmitter must be configured to communicate with the wireless network. This
step is the wireless equivalent of connecting wires from a transmitter to the information system.
Using a Field Communicator or AMS Wireless Configurator, enter the Network ID and Join Key so
that they match the Network ID and Join Key of the gateway and other devices in the network. If
the Network ID and Join Key are not identical, the 702 transmitter will not communicate with
the network. The Network ID and Join Key may be obtained from the Smart Wireless Gateway
on the Setup>Network>Settings page on the web server, shown in Figure 4-1.
Figure 4-1. Gateway Network Settings
4.3 Using AMS Wireless Configurator to configure the
transmitter
Right click on the 702 transmitter and select Configure. When the menu opens, select Join
Device to Network and follow the method to enter the Network ID and Join Key.
4.4 Using a field communicator to change the
network ID and join key
The Network ID and Join Key may be changed in the wireless device by using the following Fast
Key sequence. Set both Network ID and Join Key.
Function Key Sequence Menu Items
Wireless Setup
2, 1, 1
Network ID, Set Join Key
To Next Page
Loading...
