65
Reference Manual
00809-0200-4702, Rev CA
Section 7: Mounting, Wiring Switches and Out-
put Circuits, Models 702DX32 and 702DX42
February 2013
Mounting, Wiring Switches, and Output Circuits:
Models 702DX32 and 702DX42
Note
Wireless devices should only be powered up after the Smart Wireless Gateway, in order of
proximity from the Smart Wireless Gateway beginning with the closest device. This results in a
simpler and faster network installation.
Figure 7-2. Power Module Installation
5. Close the housing cover and tighten to safety specifications. Always ensure a proper
seal by installing the electronic housing covers so that metal touches metal, but do not
over tighten.
6. The antenna should be positioned vertically, typically straight up but the antenna may
also be pointed straight down, as shown in Figure 7-3 on page 65.
Figure 7-3. Antenna Positioning
Possible antenna rotation shown.
Antenna rotation allows for best
installation practices in any
configuration.
To Next Page
Loading...
