82
Reference Manual
00809-0200-4702, Rev CA
Section 8: Commissioning: Models 702DX32 and 702DX42
February 2013
Commissioning: Models 702DX32 and 702DX42
Troubleshooting
If the device is not joined to the network after power up, verify the correct configuration of the
Network ID and Join Key, and verify that Active Advertising has been enabled on the Gateway.
The Network ID and Join Key in the device must match the Network ID and Join Key of the
Gateway.
Changing the Network ID and Join Key
The Network ID and Join Key may be obtained from the Gateway on the Setup>Network>Set-
tings page on the web interface (see Figure 8-5 on page 81). The Network ID and Join Key may
be changed in the wireless device by using the following Fast Key sequence.
Function Key Sequence Menu Items
Wireless 2,1,1 Join Device to Network
To Next Page
Loading...
