3
Rosemount 8600 Vortex Flow Meter
Reference Manual
May 2019
Configuration
00809-0100-4860, Rev BF
Section 2 Configuration
Review . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3
Process variables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3
Basic setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 12
2.1 Review
Review the flowmeter configuration parameters set at the factory to ensure accuracy and
compatibility with your particular application of the flowmeter. Once you have activated
the Review function, scroll through the data list to check each variable in the configuration
data list.
The last step of start-up and commissioning is to check the flowmeter output to ensure that
the flowmeter is operating properly. Rosemount 8600D digital process variables include:
primary variable, primary variable as a percent of range, analog output, vortex shedding
rate, pulse frequency, mass flow, volumetric flow, velocity flow, totalizer, electronics
temperature, calculated process density, cold junction temperature, and process
temperature.
2.2 Process variables
The process variables for the Rosemount 8600D provide the flowmeter output. When
commissioning a flowmeter, review each process variable, its function and output, and take
corrective action if necessary before using the flowmeter in a process application.
This product is intended to be used as a flowmeter for liquid, gas, or
steam applications. Any use other than for which it was intended may
result in serious injury or death.
FastKeys
1, 5
FastKeys
1, 1
To Next Page
Loading...
