5 Engineering Assistant installation
Engineering Assistant 6.1 or later
The Rosemount
™
3051SMV Engineering Assistant 6.1 or later is PC-based
software that performs configuration, maintenance, diagnostic functions, and
serves as the primary communication interface to the Rosemount 3051SMV
with the fully compensated mass and energy flow feature board.
The Rosemount 3051SMV Engineering Assistant software is required to
complete the flow configuration.
NOTICE
To ensure correct operation, download the most current version of the
Engineering Assistant software at Emerson.com/Rosemount-Engineering-
Assistant.
5.1 System requirements
The following are the minimum system requirements to install the
Rosemount
™
3051SMV Engineering Assistant software:
• Pentium
®
-grade processor: 500 MHz or faster
• Operating system: Windows
™
XP Professional (32-bit), or Windows 7 (32-
bit or 64-bit)
• 256 MB RAM
• 100 MB free hard disk space
• RS232 serial port or USB port (for use with HART
®
modem)
• CD-ROM
5.2
Install Rosemount 3051SMV Engineering Assistant 6.1 or
later
Procedure
1. Uninstall any existing versions of Engineering Assistant 6.
2. Insert the new Engineering Assistant disk into the CD-ROM.
3. Windows
™
should detect the presence of a CD and start the
installation program. Follow the on-screen prompts to finish the
installation. If Windows does not detect the CD, use Windows Explorer
or My Computer to view the contents of the CD-ROM, and then double
click the SETUP.EXE program.
4. A series of screens (Installation Wizard) will appear and assist in the
installation process. Follow the on-screen prompts. It is recommended
to use the default installation settings.
October 2018 Quick Start Guide
Quick Start Guide 15
To Next Page
Loading...
