Need help?Do you have a question about the Emerson SKCD200220 and is the answer not in the manual?
Risks associated with electric shock, isolation, stored charge, and ground leakage.
Diagrams detailing power terminal connections for various drive sizes.
Safety warnings for control circuits and PCB edge connectors.
Step-by-step guide for navigating and editing drive parameters using the keypad.
Introduces parameter levels and describes Pr 01-10 for basic setup.
Covers drive configuration (Pr 05) and related terminal connections.
Settings for motor characteristics, brake control, and start/stop logic.
Parameters for autotune, switching frequency, motor poles, voltage modes, and communication.
Minimum required control terminal connections for basic operation.
Minimum required control terminal connections for keypad-based operation.
Procedures for powering up, entering basic settings, and performing motor autotune.
List of trip codes, their conditions, and possible causes for troubleshooting.
General| Horsepower | 2 HP |
|---|---|
| Amperage | 8.5 A |
| Output Current | 8.5 A |
| Frequency | 50/60 Hz |
| Input Voltage | 200-240 VAC |
| Phase | Single Phase |
| Efficiency | 98% |
| Cooling Method | Fan Cooled |
| Protection Features | Overvoltage, Short Circuit |
| Operating Temperature | -10°C to 50°C |
| Storage Temperature | -20 to 60°C |
| Humidity | 5% to 95% (Non-Condensing) |
To Next Page