20 21
Thermostat Con guration
Pairing the Thermostat and HVAC Controller
Each wireless thermostat must be paired with an individual HVAC Controller during
installation. The thermostat will begin a 30 second countown as it searches for the
closest HVAC Controller to it. The HVAC Controller ID is located on the case.
➤ Verify that the HVAC Controller found by the thermostat matches the HVAC
Controller listed on the HVAC Controller in the same room;
➤ Press the F|C button to pair the thermostat with the HVAC Controller
displayed on the screen. The screen will display “SUCC” when the HVAC
Controller has been paired successfully. If the HVAC Controller ID displayed on
the screen is incorrect, press the FAN button to reject it;
➤ Press the F|C button to advance to the next con guration menu.
THE HVAC CONTROLLER MUST BE LINKED TO A THERMOSTAT IN THE SAME
ROOM. ONLY INSTALL ONE ROOM AT A TIME.
Thermostat Con guration
Setting the MESH ID
➤ Press the FAN button to advance to the next digit;
➤ Press the UP and DOWN buttons to increase or decrease the value;
➤ Press the F|C button to advance to the next menu.
To Next Page
Loading...
Need help?
General
