Sensor Type 0 1 2
OCC
Occupancy Sensor
Disabled Enabled*
DS
Door Switch
Disabled
N/C
Normally Closed
N/O*
Normally Open
RT
Temperature Sensor
Master*
Temperature Reading From
Sensor Overrides Thermostat
Average
Average of Temperature
Readings From All Sensors
& Thermostat
Average
Average of Tem-
perature Readings
From All Sensors &
Thermostat
30 31
Con guring & Managing Accessories
Discovering an Active Sensor
The thermostat will display the rst sensor discovered in the pairing process. Ensure
that the unique device number displayed on the screen matches the unique ID found
on the sensor.
➤ Press the F|C button to con gure the discovered sensor.
If the sensor displayed on the screen is not the correct sensor to pair with the HVAC
Controller, use the UP or DOWN buttons to nd other discovered sensors. To start
over, press the ON/OFF button to exit and refer back to the Accessory Con guration
section of this manual.
Con guring & Managing Accessories
Con guring the Functionality of a Sensor
The user must con gure the type of sensor being paired with the HVAC Controller.
Use the table below to con gure the correct sensor functionality.
➤ Press the F|C button to advance to the next device type;
➤ Press the UP and DOWN buttons to increase or decrease the trailing digit;
➤ Hold the F|C to save sensor settings.
*Indicates default setting.