Emerson VCR872 - Page 13

USAGE OF THE FINE TUNING BUTTONS
If your TV picture is not clear, you must perform FINE TUNING.
Press and hold the FINE TUNING button (A or V) until a clear
picture is obtained.
Too far in the
HIGH direction
Meshshaped
stripes appear
Normal picture Too far in the
LOW direction
Color disappears
from the picture
TABLE FOR SELECTING 3 BANDS
Press the BAND select switch until the
desired indicator lamp lights up as
shown below.
VHF/UHF
CATV
V l
CH 2 - 6
CH A-5-A-3
V H
CH 7 - 13
CH A-2 — A-1
CH A - I
CHJ-W
u
V — J
CH 14 - 83
NOTE
Do not miss FINE TUNING (step 5) in con 
sideration of bad condition of radio wave.
The AFT switch
automatically
changes to off during
operation of preset
tuning. It is recom 
mended that the AFT
switch is always at on
position.
< A Press the either Press the channel indi-
'Up(A)' or 'Down(V) ’ cator button 10's to set
FINE TUNING button number 3, and button
until UHF 31 appears i ’ s to set the 1, to
clear on the TV screen. change to 31 in channel
display.
To operate the FINE
TUNING buttons cor 
rectly, see above
instructions
Press the PRESET but-
ton again and PRESET
indicator goes off and
AFT indicator lightsup.
NOTE
Unless pressed this
button, your desired
channel should not be
t memoried.