Emerson VCR872 - Presetting the Channels

PRESETTING THE CHANNEL
THE TUNER BUILT INTO YOUR VCR CAN RECEIVE ANY REGULAR TV CHANNELS
FROM 2 THROUGH 83 OR 27 CABLE CHANNELS. EACH OF SIXTEEN CHANNEL
NUMBERS CAN BE PRESET TO ANY OF THE CHANNELS MENTIONED ABOVE.
YOUR VCR HAS BEEN ADJUSTED AT THE FACTORY FOR VHF CHANNEL 2
THROUGH 13, HOWEVER, YOU MAY PROGRAM ANY OR ALL OF 16 PRESET
CHANNEL NUMBER MEMORIES IN ANY SEQUENCE FOR YOUR CONVENIENCE.
PREPARATION
• Turn on the TV POWER switch and set to the video channel 3 or 4.
• Turn on the VCR POWER switch.
• Open the compartment door.
• Set the VCR/TV selector to VCR.
• Make sure that the timer display shows the present time correctly.
• Make sure that the TIMER REC switch is OFF.
FOR EXAMPLE: TO CHANGE VHF 11 TO UHF 31 CHANNEL ON THIS VIDEO
Press the PRESET but- Select channel ll with
ton, and PRESET indi- either ’ Up(A)' or
cator lights up and AFT ’ Down(V) ’ channel
indicator goes off. button on VCR.
Press the BAND select
switch until UHF indi 
cator lamp lights up.
* To set the BAND
select switch to your
desired channel, see
the right-above table.
(3S Press the ’ Up(A) ’
TUNING button until
UHF 3 1 appears on
TV,
- 10 —